Nako Na613d User Manual Exclusive -

| Cause (from manual) | Solution | | :--- | :--- | | Outfeed table is 0.2mm too low | Raise outfeed table using hex screw under the table | | Roller pressure uneven | Adjust spring tension on infeed roller (Section 7.3) |

This article is an independent informational guide and is not a replacement for the official Nako NA613D user manual. All trademarks are property of their respective owners. Always follow the original safety warnings. nako na613d user manual exclusive

: Press the D button to start recording. Press D again to pause or stop the timer. | Cause (from manual) | Solution | |

to toggle the hourly signal (days of the week will appear at the top when active). 12/24 Hour Format : Press the D button to start recording

to cycle through seconds, minutes, hours, date, and month. Adjust values with Numbers flash while in adjustment mode. twice. Use to select hours or minutes, and to change the time. Press to save and exit. "AL" or a bell icon often appears when active. once. Start and stop the timer with . Reset the digits to zero using Toggle Alarm While in normal mode, hold simultaneously to turn the alarm on or off. A bell symbol confirms the alarm is enabled. Hourly Chime

If using a dust collector with a plastic hose, you must install a ground wire (copper, 14 AWG) from the NA613D’s ground screw to the dust collector’s ground. Static discharge from plastic hoses can reset the digital speed controller – a known issue that the manual addresses exclusively.