This method replaces the problematic Prolific driver with a version that Windows 10 still accepts.
Here is a prepared piece outlining the necessary software, drivers, and configuration steps. k150 pic programmer software windows 10
If you plug in your K150 and see a yellow triangle in , follow these steps to install the compatible driver: This method replaces the problematic Prolific driver with
| Issue | Likely Cause | Solution | |--------|--------------|----------| | "Programmer not found" | Wrong COM port | In Device Manager, check which COM port the K150 uses (e.g., COM4). Set software to that port. | | "Device cannot start (Code 10)" | Windows blocked the driver | Reinstall driver v3.2.0.0 with driver signature enforcement disabled. | | Verification fails at address 0 | Power issue | The K150 draws power from USB. Use a powered USB hub if programming chips that require more current (like 16F877A). Also check your PIC’s oscillator settings. | | Erase works, but write fails | Voltage level problem | Some K150 clones have poor voltage regulation. Ensure you are not programming a chip already in a powered circuit. | | Software freezes on Windows 10 64-bit | 32-bit legacy software conflict | Switch to MCP software (64-bit compatible) or run PICPGM in Windows 7 compatibility mode (right-click → Properties → Compatibility). | Set software to that port