Narco Escort Ii Installation Manual Full _verified_ (2026)

The primary interface is the . For 14V aircraft, you must jumper Pins 8 and 10 . Wiring Note 1 & 2 +14/28V Power Input Use 18 AWG Red wire 3 & 4 Airframe Ground Use 18 AWG Black wire 5 Low Level Audio 20 AWG Green; used for audio panels 6 Headphone Audio 20 AWG Blue; 50 mW into 300 ohms 11 Mike Audio 20 AWG Brown 12 Intercom Key 20 AWG Yellow; grounds to activate 13 Mike/Phone Ground 20 AWG Black 3. Antenna Connections

Use the specialized Narco locking hex-wrench tool to tighten the internal cam-lock. Do not over-tighten, as this can warp the mounting frame. 3. Wiring and Pin Assignments narco escort ii installation manual full

: Consider backing up your system before installing new software, especially if it's complex or you are unsure of its compatibility. The primary interface is the

Once installed, power on the unit and verify the gas discharge display is functional. narco avionics escort ii - AeroElectric Wiring and Pin Assignments : Consider backing up

: A 1.5 amp circuit breaker must be provided between the unit and the aircraft power bus.

The P301 connector facilitates the primary electrical interface for the Escort II. Note that for 14V systems, a jumper is required between pins 8 and 10. 14/28V Power Input Airframe Ground Low Level Audio Headphones Audio (50 mW across 300 ohms) Transmitter A+ Transmitter Key Switched A+ Mike Audio Intercom Key Mike/Phones Ground

Pin 2 (+14V) must be fed from a dedicated "Avionics Master" or "Transponder" breaker. Do not share these with a cigar lighter or landing light circuit. Voltage drop must be <0.5V under load.