User Manual — Trimble Tsc3

Avoid leaving the controller on a vehicle dashboard in direct sunlight, as extreme heat can degrade the battery and screen adhesive.

The TSC3 has an internal GNSS antenna (only for SBAS/WAAS, not for RTK). For real-time work, you must connect to an external receiver (R10, R8, SPS, etc.).

: Runs on Windows Embedded Handheld 6.5 Professional . trimble tsc3 user manual

To effectively use or troubleshoot your Trimble TSC3 controller Go to product viewer dialog for this item.

That night, alone in the motel room, he brewed burnt coffee in a stained mug and opened the manual to Chapter 1: Getting Started . He read past the warnings about electrostatic discharge. Past the diagrams of the SD card slot. He stopped at a small, gray sidebar he’d never noticed before: Avoid leaving the controller on a vehicle dashboard

were sealed tight to protect against the morning dew, as recommended in the standard setup guide. 2. Creating the Digital Blueprint With the unit powered on, Elias navigated the Windows Embedded Handheld 6.5 interface to launch Trimble Access Project & Job Creation: to create a project, then added a

The TSC3 is primarily used to run or SCS900 Site Controller software. Trimble TSC3 Controller Data Collectors : Runs on Windows Embedded Handheld 6

28.9 Wh Li-Ion rechargeable battery offering up to 34 hours of operation under normal conditions, with a full charge cycle of 3 hours.