Nexiq Usb Link 2 Clone Driver Exclusive !!install!!
These often work with the official Nexiq USB Link 1 drivers .
A common issue with clones is the system reverting to generic "Jungo" drivers, which prevents diagnostic software like DDDL from reading vehicle parameters. Essential Installation Steps for Clones nexiq usb link 2 clone driver exclusive
: Official drivers include firmware checks that can permanently disable (brick) a clone device. These often work with the official Nexiq USB Link 1 drivers
Legal and support considerations
https://bst.cloudapps.cisco.com/bugsearch/bug/CSCve43726/?referring_site=bugquickviewredir
I found this bug from Cisco. Also, change to network type.
Hi,
I’m trying to do this with a newer version – csr1000v-universalk9.16.03.06
Do you know what should be the SHA1 for this ? or on which file can I find it ?
I can’t find it
thanks…
Update :
Hi,
I also tried to download the exact version you used here, and changed the SHA1, and it didn’t worked too…
I’m getting an error again : “the checksum not match”
any clue what am I doing wrong ?
Very good article and troubleshooting. Additionally please do change “virtio lsilogic” to “lsilogic” for the SCSI Controller to make it work.
Also mentioned by Stephen in the first comment but realized it after struggling, finding the issue and fixing a few hours later!