Hp — Fxn1 E93839 Motherboard Specs Updated

| Specification | Details | |---------------|---------| | | Proprietary AiO (fits specific HP chassis – not Mini-ITX/ATX) | | Socket | LGA 1151 | | Chipset | Intel H110, B150, or Q150 (varies by sub-model; H110 most common) | | CPU Support | Intel Core i3/i5/i7 (6th & 7th gen), Pentium, Celeron | | Memory | 2 x SODIMM slots (DDR4, 2133/2400 MHz, max 32 GB) | | Storage | 1 x SATA 3.0 (6Gb/s), 1 x M.2 2280 (SATA or PCIe x2 NVMe) | | Expansion | 1 x PCIe x4 (low-profile, proprietary orientation) | | Video Output | Internal LVDS/eDP for built-in display; 1 x DisplayPort (back) | | Audio | Realtek ALC (typically ALC3228 or ALC221) | | LAN | Realtek RTL8111HSH (Gigabit Ethernet) | | Wireless | 1 x M.2 2230 slot (for Wi-Fi/BT combo card) | | Rear I/O | 2 x USB 3.0, 2 x USB 2.0, RJ45, Audio out, Mic in, DC power jack | | Power | External 19.5V DC adapter (90W–150W depending on CPU) | | BIOS | HP UEFI (non-standard, requires HP-specific BIOS updates) |

This is the most important section for anyone upgrading. hp fxn1 e93839 motherboard specs updated

🎛️ – The headers for the power button, power LED, and reset switch are non-standard. Mapping standard case cables to this board requires custom wiring or an enthusiast mapping diagram. HP motherboard E93839 FXN1 With Intel I5-6500 - eBay | Specification | Details | |---------------|---------| | |

The number "e93839" often appears in searches for this board because it is the printed on the PCB (Printed Circuit Board). Foxconn is the OEM manufacturer for HP. HP motherboard E93839 FXN1 With Intel I5-6500 -

Since this is an OEM board, pay close attention to the power connectors. Standard 24-pin ATX + 4-pin 12V CPU Form Factor: Micro-ATX (Approx. 24.4 cm x 24.4 cm) Mounting: Standard 6-screw or 7-screw holes ⚠️ Compatibility Warnings

| Problem | Solution | | :--- | :--- | | | You used a standard PSU. Install a HP proprietary PWM adapter or short the sense pin (pin 20 to ground). | | No POST with 8GB modules | Only double-sided (2Rx8) DDR3 DIMMs are supported. Avoid 8GB single-sided (1Rx8) modules. | | USB 3.0 ports fail after sleep | Install Intel USB 3.0 driver version 5.0.4.43 or newer. | | GPU not recognized | Disable Secure Boot and enable “Legacy Boot” in BIOS. Some GPUs require UEFI GOP – this board uses legacy VBIOS only. |

Using an + 16GB DDR3-1600 + SATA III SSD :