Kt 70 Installation Manual Jun 2026

This structured approach ensures that the KT 70 is installed according to manufacturer specifications and safety standards.

| Code | Cause | Solution | |------|-------|----------| | | Sensor open or reversed | Check continuity; reverse TC wires (no polarity on RTD) | | HHH | Input > range | Sensor type mismatch or short circuit | | LLL | Input < range | Sensor disconnected or below zero | | E.OP1 | Output 1 short-circuit | Check SSR or heater coil resistance | Kt 70 Installation Manual

: Installers must remove the Electrostatic Discharge (ESD) tape from the back connectors before use, as leaving it in place can cause the microprocessor to short out. Post-Installation and Configuration This structured approach ensures that the KT 70